Unigine::Cigi::ICigiTrackerControl Class
Header: | #include <CigiClientInterface.h> |
Inherits: | ICigiHostPacket |
This class represents the CIGI Motion Tracker Control packet interface.
CIGI plugin must be loaded.
ICigiTrackerControl Class
Members
int getViewID()
Returns the view ID specified in the packet.Return value
View ID.int getTrackerID()
Returns the tracker ID specified in the packet.Return value
Tracker ID.int getTrackerEnabled()
Returns the value of the Tracker Enable parameter specified in the packet.Return value
Tracker Enable parameter: 1 if the tracking device is enabled; otherwise, 0.int getBoresightEnabled()
Returns the value of the Boresight Enable parameter specified in the packet.Return value
Boresight Enable parameter: 1 if the boresight state of the tracking device is enabled; otherwise, 0.This mode is used to reestablish the tracker’s “center” position at the current position and orientation. When enabled is enabled, the Host shall send a Motion Tracker Control packet with Boresight Enable set to Disable (0) to return the tracker to normal operation. The IG shall continue to update the boresight position each frame until that occurs.
int getGroupSelect()
Returns the value of the View/View Group Select parameter specified in the packet.Return value
View/View Group Select parameter: 1 if the tracking device is attached to a view group; 0 - if the tracking device is attached to a single view.iconst Math::vec3& getOffsetEnabled()
Returns a three-component vector combining Offset Enable values specified in the packet. Each value determines whether the offset for the corresponding axis(X - back, Y - left, Z - down) is enabled.Return value
Vector of three integer values. Each value determines whether the offset for the corresponding axis(X - back, Y - left, Z - down) is enabled: 1 - enabled; 0 - disabled.const Math::ivec3& getRotationEnabled()
Returns a three-component vector combining Roll/Pitch/Yaw Enable values specified in the packet. Each value determines whether the rotation around the corresponding axis(roll, pitch, yaw) is enabled.Return value
Vector of three integer values. Each value determines whether the rotation around the corresponding axis(Roll, Pitch, Yaw) is enabled: 1 - enabled; 0 - disabled.Last update: 2017-10-20
Help improve this article
Was this article helpful?
(or select a word/phrase and press Ctrl+Enter)