shown in other instead.
AlphaMapper is used to create an alpha map based on a high-poly mesh with the specified accuracy and bake it into the diffuse map in just a few clicks. When alpha test will be performed for a mesh material, the generated alpha map will define which areas are visible and which are invisible and not drawn. It can be used to improveme appearance of grids, latices, thin bars, etc.
To create an alpha map do the following:
- Load a low-poly mesh for which alpha map will be created by clicking Load Low.
- Load a high-poly mesh used as a reference for created alpha map by clicking Load High.
- If necessary, load a diffuse texture into which an alpha map will be baked using Diffuse Mapoption.
- Set alpha map options at the right side of the ResourceEditor window.
- Click Runto start the process. After the alpha map is created, it can be seen at theAlpha Mapviewing pane.
- Click Saveto save the alpha map. If a diffuse texture was loaded, the alpha map will be baked into its alpha channel.
AlphaMapper has two viewing panes. The display mode can be switched in the drop-down list in the upper left corner of each pane.
|Load Low||Load a low-poly mesh for which alpha map will be created (for example, a simple plane).
You can also load the low-poly mesh by pressing Ctrl+O.
|Load High||Load a high-poly mesh based on which an alpha map will be baked.
You can also load the high-poly mesh by pressing Ctrl+H.
|Diffuse Map||Load a diffuse texture into alpha channel of which the created alpha map will be saved.
You can also load the diffuse map by pressing Ctrl+D.
|Reload||Reload a mesh or a diffuse texture.|
|Clear||Remove a mesh or a diffuse texture.|
|Reload All||Reload meshes along with a diffuse texture, if any, and clear the alpha map.
You can also reload resources by pressing Ctrl+R.
|Run||Create an alpha map that specifies visible and invisible areas for alpha-tested materials. The result applied to the model can be seen in the Alpha Mapmode.|
|Save||Save the calculated alpha map into the texture. See supported formats into which the texture can be saved. There are some options present while saving:
You can also save the alpha map by pressing Ctrl+S.
The set of visualization options:
|Info||Display information about the mesh that is currently in the viewport. Such data is shown as a number of surfaces, vertices and triangles.
You can also enable the option by pressing I.
|Compass||Toggle an XYZ compass in the upper right corner of the viewport.
You can also enable the option by pressing C.
|Triangles||Toggles showing a base grid plane.
You can also enable the option by pressing T.
Alpha Map Options
Supported File Formats
Supported formats of geometry data:
- Unigine mesh (.mesh)
- Unigine skinned mesh (.smesh)
- Wavefront (.obj)
- COLLADA (.dae)
- FBX (.fbx)
Supported formats of textures:
- Targa (.tga)
- Portable Network Graphics (.png)
- JPEG (.jpg)
- Photoshop Document (.psd)
- Direct Draw Surface (.dds)
- Portable Pixmap (.ppm)
- Portable Graymap (.pgm)
- High Dynamic Range (.hdr)
- Silicon Graphics Image (.sgi)
- Tagged Image File (.tif)
- Ctrl+O — load a low-poly mesh.
- Ctrl+H — load a high-poly mesh.
- Ctrl+D — load a diffuse texture.
- Ctrl+R — reload all resources.
- Ctrl+S — save the alpha map or bake it into the loaded diffuse texture, if any.
- I — toggle mesh info.
- C — toggle a XYZ compass.
- T — toggle base grid.
- G — reset pivot from the mesh to the camera.