从Blender导出3D模型

This article describes how to export your 3D Model From Blender so that it would have proper scaling, position, and orientation when imported to UnigineEditor.本文介绍如何从Blender导出3D模型，以便在导入到UnigineEditor时具有正确的缩放比例，位置和方向。

Before the export, do the following:导出之前，请执行以下操作：

• Check that Meters are set as working units.检查仪表是否设置为工作单位。

  

  Blender scale should be: 1 unit = 1 meter.Blender标度应为：1 unit = 1 meter。

  For convenience, you can set the grid cell size equal to 1 meter:为了方便起见，您可以将网格像元大小设置为等于1米：

  

• Orient the model towards the negative direction of the Y axis, which is the front direction in Blender.将模型朝向Y轴的负方向（即Blender中的正向）定向。

  

• Set the actual model size.设置实际模型尺寸。

• Apply all transforms (Object -> Apply -> All Transforms).应用所有变换（Object -> Apply -> All Transforms）。

  After applying all transforms, a part of model can be misplaced due to complex parenting. In this case, first clear parent (Object -> Parent -> Clear and Keep Transform), then apply transforms, and finally restore parent, if necessary.应用所有转换后，由于复杂的育儿，模型的一部分可能会放错位置。在这种情况下，请先清除父代（Object -> Parent -> Clear and Keep Transform），然后应用转换，最后在必要时还原父代。

• Check that materials are ready for export.检查材质是否准备好出口。

As soon as your model is ready for export, click File -> Export -> FBX. Check that the parameters set in the Transform section are as follows:一旦准备好导出模型，请单击File -> Export -> FBX。检查在Transform部分中设置的参数是否如下：